Rear subframe solid mount
Rear subframe solid mount
Had a nosey on the old forum but I can't seem to search it it keeps timing out on me. So far I've found that folk replace the rubber pads with steel and drill them into the rear floor. Problem is I've got my subby off and it doesn't have any rubber pads on. Never seen any pics of this so I've no idea where they are supposed to be. Can anyone give me an insight as to where they are supposed to live and How thick they are.
N447AKU Kingfisher Blue R116 Kensington (SCRAP)
M356NVP Flame Red R114 Gta (WRITE OFF)
M752PDB Kingfisher Blue R111 Kensington SE (CURRENT PROJECT)
MM07XDP Red Pugeot 107 (DAILY)
M356NVP Flame Red R114 Gta (WRITE OFF)
M752PDB Kingfisher Blue R111 Kensington SE (CURRENT PROJECT)
MM07XDP Red Pugeot 107 (DAILY)
Re: Rear subframe solid mount
there is a small "bracket" pressed into the floor behind and a bit forward in relation to the rear bump stop. just behind the inner arch lip. this is where the rubber pad sites between the subframe and car.
'84 Mk1 Hill Climb Metro
'93 Rover 114GTI
'89 Austin Metro Special 998
'99 Rover 400 - sold
'02 Rover 75 cdti tourer
'85 MG Metro
'93 Rover 114GTI
'89 Austin Metro Special 998
'99 Rover 400 - sold
'02 Rover 75 cdti tourer
'85 MG Metro
Re: Rear subframe solid mount
Cheers for that dotmatrix you wouldn't happen to know the size of the pads would you?
N447AKU Kingfisher Blue R116 Kensington (SCRAP)
M356NVP Flame Red R114 Gta (WRITE OFF)
M752PDB Kingfisher Blue R111 Kensington SE (CURRENT PROJECT)
MM07XDP Red Pugeot 107 (DAILY)
M356NVP Flame Red R114 Gta (WRITE OFF)
M752PDB Kingfisher Blue R111 Kensington SE (CURRENT PROJECT)
MM07XDP Red Pugeot 107 (DAILY)
Re: Rear subframe solid mount
no sorry. I have never measured one. but I know they are different from mk1 to mk2
'84 Mk1 Hill Climb Metro
'93 Rover 114GTI
'89 Austin Metro Special 998
'99 Rover 400 - sold
'02 Rover 75 cdti tourer
'85 MG Metro
'93 Rover 114GTI
'89 Austin Metro Special 998
'99 Rover 400 - sold
'02 Rover 75 cdti tourer
'85 MG Metro