6 Spoke Alloys Fit

[AlunReynolds]

Hi

I have a set of 5 off genuine Rover 6 spoke 13 inch alloys. When I tried to fit them, the central hole in the wheel was too small to fit over the centre of the hub on my R registered Rover 100 Ascot SE. Does anyone know if these are supposed to fit without modification or do they perhaps need spacers?

Any help will be much appreciated.

If I cannot get them to fit, I will be selling them. Four of them are newly, professionally refurbished and I am in the process of making replacement alloy centre caps to finish them off.

Regards
Alun

[DotMatrix]

if its the alloys I think it is there shouldn't be a problem fitting them. there can be a need for spacers if running vented disks.

take a look at: https://www.metropower.info/how-to-guid ... nformation

[Pickford]

IIRC ascot se would have solid rather than vented. If the alloys are genuine then in theory they should fit maybe the brakes are aftermarket and the centre bore is wrong?
As dotmatrix says if your brakes are vented you will need spacers, these are 3mm thick and available from ebay.