Hello all, I am putting my metro back together after a spell off the road. I have a 1.8 non vvc with Mems 1.9 and 5as? The car was converted a fair few years ago using a custom loom and I think Jon boy did the install. I have popped on a new battery, I have put a new battery on the remote plip thing...

thanks for the reply. my metro had spotlights which were triggered via the main beam light on the dash - this powered a switch below the rear screen heater- the this went to a relay located near the battery. i have disconnected this. am worried may have messed up the dash clocks... I plan to look at...

Hello all, I am putting my G reg GTI back together. It has been to a body shop that cut the wires to the door so that they could take it off and they cut the loom down the passenger side just before the fuel pump connections. its been tricky putting it back together as I did not take it apart... I r...

Hello all, My metro has come back from the body shop after having some welding done... the car is in a bit of a mess.. The chap has cut the wiring loom where the loom passes from the sill trim into the side of the car and over the wheel arch to reach the back. I am OK soldering it all back together ...

Cheers - I will have a look!
many thanks

Hello all,
I need some parts to complete my metro restoration :
Drivers side "A" pillar - 3 door
scuttle panel

can any one help with these parts ?
cash ready - can collect if local to south west


cheers
Shaun

Hello Guys Its been cold - so I have left the MG I bought a code reader from the internet and plugged that into the OBDC and I can read the ECU number etc. but there are no fault codes. After the beast from the east - I re-connected the battery negative lead - and the car fired up straight away - bu...

Hello all I took to-day off and had a good probe around under the bonnet of the MGZR - I have the VVC plugs in the correct place as the engine will rev to 7500 rpm - but looking at these plugs - noticed that below the throttle body - there is the inlet tract & injector no4 which has a sensor screwed...

Hello all, Since my last post - I have not done much on the car due to DIY commitments! Have considered just selling the lot on an internet site as a going concern! Opening the bonnet on the MGZR - with the engine cam belt to the right - the big Silver VVC control thing has a black plug on it - then...

cool
I will try checking the plugs - many thanks