Hi, what you need to remember, is that the antifreeze not only has freeze protection, but also has corrosive protection as well, so imo, the higher the antifreeze strength, the better, as I have seen brown fluid come out of suspension cans, when it should be green/yellow, so cans were full of corros...

If its got the black module on the side of the Dizzy, Its prob that,
they are well known for it.

you can use the front or rear subframe from a mgf, if using the rear, you will need to remove the plate that covers where the steering rack goes, but frame will have the sump tie bar bracket on' if using the front subframe, the steering rack mounting is done, but you will need to weld on a sump tie ...

The engine will fit, but use either R65 flywheel 1400 or 1600 for the 200mm clutch, also ensure that flywheel has correct crank sensor pattern, (there are 2 types for the 3AS, (mems1.6) alarm, pressed steel ring pattern, 1 type for 5AS, mems1.9, 2J, mems 3, all same. (not 1100 flywheel as its only a...

Yes, double sided tape, but take your time as these are like rocking horse sh*t to get now.

What is the engine number on the tag on the block?

Pour hot water (or heatgun it) along the top of the moulding to soften the tape that holds it, problem with removing these mouldings is that they go rippley if you dont take your time, so they look crap when you put them back on. Or you could cheesewire along the fixing tape, take the top moulding o...

You wont be able to fit the gearbox from the R75 as it is a Getrag box, completely different
from PG1, as is the flywheel.

That's the Choke warning, you have left the choke on.

Normally , if nothing else is wrong, any light mayo will disappear when the car is given a good run, If the car runs ok for a couple of mins, then stops, I would start with checking that all the correct elec plugs are on the correct positions, is the correct plug on the O2 sensor? because on cold st...